Latest Products

Move pointer over the image to zoom in

Motor-driven expansion board L293D motor control shield For arduino

7.13€
Qty:
Print

L293D is a monolithic integrated, high voltage, high current, 4-channel driver. Basically this means using this chip you can use DC motors and power supplies of up to 25 Volts, that"s some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what"s known as a type of H-Bridge. The H-Bridge is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor. Features : 2 interface for 5V Servo connected to the Arduino"s high-resolution dedicated timer - no jitter. Can drive 4 DC motors or 2 stepper motors or 2 Servo. Up to 4 bi-directional DC motors with individual 8-bit speed selection. Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping. 4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 25V DC. Pull down resistors keep motors disabled during power-up. 2 external terminal power interface, for separate logic/motor supplies. Tested compatible for Arduino Mega, Diecimila and Duemilanove.L9110S DC Stepper Motor Driver Board H Bridge FZ0537

Description:

Low quiescent current

Wide supply voltage range: 2.5V-12V

800mA per channel continuous power output capability

Lower saturation voltage

TTL / CMOS compatible output level can be directly connected to CPU

Output built-in clamp diodes for inductive load

Control and drive integrated into a single IC

With pin high-voltage protection

Operating temperature :0-80

Onboard 2 L9110S motor control chip

Module can drive two DC motors or a 4-wire two-phase stepper motor

Package Included:

5 X L9110S Motor Driver

  • Availability: 2

Powered by Abantecart eCommerce Solution